• Choose Language
  • Research papers

    This section contains a selection of abstracts of papers published by R&D employees.

    Further information about the subject matter presented in the papers can be obtained from the conference organisers, the publishers quoted or through your nearest university library.

     

    The effect of time evolution and timing of the electrochemical data recording of corrosion inhibitor protection of hot-dip galvanized steel

    3 Jun 2020

    M. Meeusen, J.M.C Mol; Delft University of Technology, Delft, the Netherlands L. Zardet, M. Lekka, F. Andreatta, L. Fedrizzi; University of Udine, Udine, Italy A.M. Homborg; Netherlands Defence Academy, Den Helder, the Netherlands B. Boelen; Tata Steel IJmuiden, Research and Development, IJmuiden, the Netherlands H. Terryn; Delft University of Technology, Delft, the Netherlands ; Vrije Universiteit Brussel, Brussels, Belgium

    Find out more
    Modelling of friction in hot stamping

    8 May 2020

    Jenny Venema; Tata Steel, Research & Development, IJmuiden Eisso Atzema; Tata Steel, Research & Development, IJmuiden and University of Twente, Enschede Javad Hazratib, Ton van den Boogaard, David Matthews; University of Twente, Enschede

    Find out more
    Temperature dependence of steel constitutive behavior: a simplified model

    7 May 2020

    Eisso Atzema; Tata Steel, R&D, IJmuiden and University of Twente, Enschede Hans Mulder; Tata Steel, R&D, IJmuiden

    Find out more
    Tailoring vapor-deposited ZnMg-Zn bilayer coating for steels by diffusion-driven phase transformation

    4 May 2020

    S. Sabooni, E. Galinmoghaddam, L.Q. Lu, Y.T. Pei; University of Groningen, The Netherlands A.A. Turkin; National Science Center “Kharkiv Institute of Physics and Technology”, Kharkiv, Ukraine R.J. Westerwaal, C. Boelsma, E. Zoestbergen; Tata Steel, IJmuiden, The Netherlands

    Find out more
    Correlative analysis of interaction between recrystallization and precipitation during sub-critical annealing of cold-rolled low-carbon V and Ti–V bearing microalloyed steels

    15 Apr 2020

    Ishwar Kapoor, Geoff West, Zushu Li; WMG, University of Warwick, Coventry Yongjun Lan; Tata Steel, Coventry Technology Centre, Coventry Arjan Rijkenberg; Tata Steel, 1970, CA IJmuiden Vit Janik; WMG, University of Warwick, Coventry and Institute for Future Transport and Cities, Coventry University, Coventry

    Find out more
    Recycling and utilization of high volume converter steel slag into CO2 activated mortars : the role of slag particle size

    13 Apr 2020

    Gang Liu, Katrin Schollbach, Miruna V.A. Florea, H.J.H. Brouwers; Eindhoven University of Technology, Eindhoven Sieger van der Laan; Eindhoven University of Technology, Eindhoven and Tata Steel R&D, IJmuiden Pei Tang; Wuhan University of Technology, Wuhan

    Find out more
    Lowering iron losses during slag removal in hot metal desulphurisation without using fluoride

    9 Apr 2020

    Frank N. H. Schrama, Elisabeth M. Beunder; Tata Steel R&D, IJmuiden Rhian Woolf, Alison Tuling; Tata Steel, Port Talbot Fuzhong Ji, Adam Hunt, Peter Warren; Materials Processing Institute, MPI, Middlesbrough Jilt Sietsma, Rob Boom, Yongxiang Yang; Delft University of Technology, Delft

    Find out more
    Rotating heat pipe assisted annealing

    12 Mar 2020

    Metin Celik; Tata Steel, R&D IJmuiden

    Find out more
    General mass balance for oxygen steelmaking

    28 Feb 2020

    N. Madhavan, G. A. Brooks, M. A. Rhamdhani; Swinburne University of Technology, Hawthorn, Australia B. K. Rout, F. N. H. Schrama, A. Overbosch; Tata Steel, IJmuiden, The Netherlands

    Find out more
    Effect of Silicon, Manganese and Heating rate on the ferrite recrystallization kinetics

    12 Feb 2020

    Monika Krugla, Dave Hanlon; Tata Steel, R&D, IJmuiden Vitesh Shah, Sven Erik Offerman, Jilt Sietsma; Delft University of Technology, Delft

    Find out more
    Fundamentals of the adhesion of physical vapor deposited ZnMg-Zn bilayer coatings to steel substrates

    8 Feb 2020

    S. Sabooni, M. Ahmadi, E. Galinmoghaddam, Y.T. Pei; University of Groningen, Groningen R.J. Westerwaal, C. Boelsma, E. Zoestbergen; Tata Steel, IJmuiden G.M. Song; Schunk Xycarb Technology, Helmond

    Find out more
    Influence of martensite-austenite interfaces on bainite formation in low-alloy steels below Ms

    6 Feb 2020

    Ashwath M. Ravi; Tata Steel R&D, IJmuiden and Delft University of Technology, Delft Alfonso Navarro-Lopez, Jilt Sietsma, Maria J. Santofimia; Delft University of Technology, Delft

    Find out more
    Impact of austenite grain boundaries and ferrite nucleation on bainite formation in steels

    6 Feb 2020

    Ashwath M. Ravi; Tata Steel R&D, IJmuiden and Delft University of Technology, Delft Ankit Kumar; Delft University of Technology Delft and Max-Planck-Institut für Eisenforschung, Düsseldorf Michael Herbig; Max-Planck-Institut für Eisenforschung, Düsseldorf Jilt Sietsma, Maria J. Santofimia; Delft University of Technology, Delft

    Find out more
    Interaction of precipitation with austenite-to-ferrite phase transformation in vanadium micro-alloyed steels

    22 Jan 2020

    Chrysoula Ioannidou, Zaloa Arechabaleta, Alfonso Navarro-López, Jilt Sietsma, S. Erik Offerman, Catherine Pappas, Ad A. van Well; Delft University of Technology, Delft Arjan Rijkenberg; Tata Steel Europe, IJmuiden Robert M. Dalgliesh; Rutherford Appleton Laboratory, Chilton, Oxfordshire Sebastian Kölling; Eindhoven University of Technology, Eindhoven Vitaliy Bliznuk; Ghent University, Ghent

    Find out more
    Microstructure‐based modeling of mechanical properties and deformation behavior of DP600 dual phase steel

    1 Jan 2020

    Shengci Li, Chengyu Guo, Leilei Hao, Yonglin Kang; University of Science and Technology Beijing, Beijing Yuguo An; Tata Steel, Research and Development, IJmuiden

    Find out more
    Cracking Behavior and Formability of ZnAlMgCoatings

    11 Dec 2019

    Bekir Salgin; Tata Steel IJmuiden, R&D, IJmuiden Masoud Ahmadi, Bart J. Kooi, Yutao Pei; University of Groningen, Groningen

    Find out more
    Crystal plasticity based predictions of mechanical properties from heterogeneous steel microstructures

    27 Nov 2019

    P.J.J. Kok, W. Spanjer, F. Korver, Y. An, M. Aarnts; Tata Steel IJmuiden, R&D, IJmuiden

    Find out more